Select Page

Notch Ready Interlocking ID Tube Clamp – Round



Looking for a notchable tube clamp? Our TMR notch ready tube clamps save you having to add a short piece of tube and weld to your fabrication project. They provide for a very clean look and save time!

When it comes to tube clamps we built a number of unique features into these that sets them apart! At TMR Customs we manufacture the world’s best roll cage clamp!

1: Both bolts can be loaded from the same direction! Gone are the days of threading in one fastener from the front side, and one fastener from the back side. Now you can mount our tube clamp extremely close to other components on your chassis without interference issues!

2: Locking feature – we use a nylon lock nut. No need to worry about stripping out the tapped holes in your clamps. The nylock nuts key into the machined pocket, eliminating the need to hold them with a wrench or socket when tightening.?

3: We machined a large 45 degree chamfer along the interlocking edges. This makes it much easier to align the clamps, especially after they have pulled from welding, or the tubes have slightly tweaked from a roll over or crash.

4: We left enough length on the small ID that is inserted into the tube that you can properly plug weld these for additional strength.

Additional information

Tubing Size

1-1/2" x .120" Wall Tubing, 1-1/4" x .120" Wall Tubing, 1-3/4" x .120" Wall Tubing, 1-5/8" x .120" Wall Tubing, 2" x .120" Wall Tubing


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.