Select Page

3/4″ Heim Steering Kit


SKU: R1307 Category:


Before you take a look at this kit consider something…

If you are using High Steer Arms, you should use the 7/8″ Heim Steering Kit; it is only $10 more and substantially stronger. This kit should only be used when using the stock knuckle mount and it is too small to safely bore to 3/4″. This is my opinion only, but the cost & weight differences are minimal and the strength difference substantial.

Not your basic steering setup, this kit uses 3/4″ Ruffstuff Heat Treated Chromoly heim joints for easier adjustment & uses much stronger 1.5″ X .25″ Wall DOM tubing. The kit can be used with stock steering position on the knuckle or High Steer arms. The arms or knuckles would need a 5/8″ bore.

One of the unique things about this setup is the Safety Misalignment. We combine the misalignment you need with the Safety Washer you also need, eliminating a join point which is a potential stress riser and an obvious shear point. We do not provide the 5/8″ bolts you will need. You must determine the length you need and it will vary with the thickness of your High Steer arm & Pitman Arm. We supply more DOM than you need because it is way too easy to make a mistake in your calculations and you can always cut tube, growing it back is the hard part!


  • This is a do it yourself style kit that requires welding by a competent person with the right equipment, don’t skimp, do it right!
  • You will need to check clearances with the steering at look to see if you need to add any bends before you cut it down to clear diff covers, sway bar mounts, etc.
  • If you are running 35″ tires or larger it is recommended to run our 7/8″ Heim Steering Kit.

You will receive:

Additional Products you may need to install this kit