RuffStuff 7/8" Heim Steering Kit *NO TUBE*




Product Details

This is your not so basic steering setup that uses 7/8" heims with easier adjustment & much stronger tubing. The kit can be used with stock steering position on the knuckle or High Steer arms. The arms or knuckles would need a 3/4" bore. 

The adjustment is easier because we add Hex Head weld bungs so a crescent wrench is your adjustment tool, not a pipe wrench which will scar the tube and if too deep cause a major stress riser. Not to mention what it does to the paint... 

You will receive:
4 - 7/8" Hex Head Weld Bungs, 2 LH & 2 RH, 14TPI for Heim Joints
4 - 7/8" Jam Nuts, 2 LH & 2 RH, 14TPI for Heim Joints 
4 - 7/8" Chromoly Heims, 2 LH & 2 RH 
2 - 7/8" to 3/4" RS Stainless Safety Misalignment 
2 - 7/8" to 3/4" RS Stainless Misalignment 
4 - 7/8" to 3/4" RS Stainless Tie Rod Misalignments 

One of the unique things about this setup is the Safety Misalignment. We combine the misalignment you need with the Safety Washer you also need, eliminating a join point which is a potential stress riser and an obvious shear point. 

We do not provide the 3/4" bolts you will need. You must determine the length you need and it will vary with the thickness of your High Steer arm & Pitman Arm.

We supply more DOM than you need because it is way too easy to make a mistake in your calculations and you can always cut tube, growing it back is the hard part! 

View More